Step-by-Step Cleaning (Takes ~10–15 minutes):
1. Unplug and Disassemble
Turn off and unplug the fountain.
Take it apart: remove the pump, filters, spouts, top and bottom pieces.
🔧 Check your user manual for specific disassembly instructions.
2. Discard Old Water
Dump out the water.
If there's visible slime or fur, rinse it off under warm water.
3. Wash Each Part
Use dish soap with warm water to clean all components.
Scrub corners and small areas with a toothbrush or small brush.
Clean the pump carefully:
Remove its cover and clean the impeller (the spinning part inside).
Rinse well.
4. Optional: Deep Clean with Vinegar
Mix 1 part white vinegar with 2 parts warm water.
Soak parts for 10–15 minutes to remove buildup and bacteria.
Rinse thoroughly.
5. Rinse and Dry
Rinse all parts well to remove any soap or vinegar residue.
Let air-dry or wipe with a clean towel.
6. Replace Filters (If Needed)
Most fountains use charcoal and foam filters.
Replace them according to the manufacturer’s schedule (usually every 2–4 weeks).
7. Reassemble and Refill
Put everything back together.
Refill with clean, filtered water.
Plug it back in — your fountain is fresh and ready!
🐾 Tips to Keep It Clean Longer
Quick Rinse: Every 2–3 days, rinse and wipe down.
Full Clean: Once a week.
Use filtered water to reduce mineral buildup.
Keep it out of direct sunlight to prevent algae.
0 comments